OBDSTAR MP001 Set (MP001 Programmer with ECU Bench Jumper) for OBDSTAR P50, DC706, X300 Pro4, X300 Classic G3, MS80, MS50, MK70
SKU
EC900
$269.00
In stock
MP001 is compatible with P003+ and has more SlMOS 18 than P003+( because the boot mode of SlMOS 18 is very special and needs more lO ports to be supported, P003+ has 4 lO ports and can't support it), and since MP001 has up to 12 lO ports, it can meet all future ECM requirements.
Categories: Default Category, Brands, OBDSTAR
OBDSTAR MP001 Set (MP001 Programmer+C4-01 Host + W004/W005/W006/ECU Bench Jumper)
OBDSTAR MP001 Introduction:
MP001 is the latest multifunctional programmer developed by OBDSTAR, which fully supports data read/write, clone, data processing functions for automotive, commercial vehicle, new energy vehicle, motorcycle, marine (jet-ski).
Compatible with OBDSTAR OBDSTAR DC706 , P50, MS80, MS50, MK70 and new OBDSTAR X300 Classic G3.
Software function
EEPROM/MCU reading and writing
Key flashing
Steering angle repair
Body computer data processing
Immo off
Pincode reading
Battery module repair
Instrument repair
and more functions are under development.
Compatible with OBDSTAR OBDSTAR DC706 , P50, MS80, MS50, MK70 and new OBDSTAR X300 Classic G3.
Software function
EEPROM/MCU reading and writing
Key flashing
Steering angle repair
Body computer data processing
Immo off
Pincode reading
Battery module repair
Instrument repair
and more functions are under development.
Features:
1. MP001 is compatible with the function of the P002 adapter (TOYOTA/FORD all keys lost adapter, HONDA/YAMAHA/SUZUKI all key lost adapter) and P003/P003+ adapter (some models of engine/transmission clone K/CAN conversion, BOOT mode read/write).
2. MP001 can replace P003, P002 adapter as well.
3. When use MP001 with DC706, just plug it in and the 706 will update the firmware then upload what it needs to configure the MP001 for whatever ECU you are connecting to. All automatic.
4. When read and write Chrysler GPEC2 ECM etc, MP001 does not require a 120ohm resistor between CAN H and CAN L wires, P003/P003+ does need it.
3. When use MP001 with DC706, just plug it in and the 706 will update the firmware then upload what it needs to configure the MP001 for whatever ECU you are connecting to. All automatic.
4. When read and write Chrysler GPEC2 ECM etc, MP001 does not require a 120ohm resistor between CAN H and CAN L wires, P003/P003+ does need it.
Note:
MP001 has P003+, P003, P002 functions.
Different tablet device models require different configuration software.
| Weight | 0.600000 |
|---|
